Chimney Liner & Rebuild in Olympia - You See the Footage Before You Get a Price

Trusted Chimney Liner & Rebuild for Olympia Homeowners

Chimney liner replacement and chimney rebuild services in Olympia typically cost between $2,800 and $8,500 depending on whether you’re resurfacing an existing flue or rebuilding from the crown down. Most liner installations we book in Olympia are completed in a single day; full rebuilds usually take two to three days depending on weather and masonry cure times. Call (360) 464-2015 and we’ll have a written price in your hands before any work starts.

Call (360) 464-2015

We’ve inspected over 38,000 chimneys since 2009, and the pattern we see in Olympia is consistent: homes built between 1960 and 1990 with original clay tile liners that have cracked during freeze-thaw cycles, or unlined brick chimneys in the older neighborhoods near Capitol Lake and the Eastside that were never built to modern NFPA 211 standards. The Pacific Northwest’s wet winters accelerate spalling and mortar deterioration. When water gets behind a compromised liner, it doesn’t just damage the flue; it reaches the framing. That’s when a liner repair becomes a partial rebuild, and why we run a camera before quoting anything. Every inspection we perform follows NFPA 211 Level 2 protocol, includes a documented photo record under Haven Standard Clause 4, and produces a written scope and price before you decide. No exceptions.

What Our Chimney Liner & Rebuild Service Includes

Stainless Steel Liner Installation

A stainless steel liner is a continuous metal flue pipe inserted down the chimney to contain combustion byproducts and protect the masonry from corrosive exhaust. In Olympia, we install these most often in homes with oil or wood-burning appliances where the original clay tile has cracked or the chimney was built without a liner at all. Our crews use DuraFlex and Olympia Chimney stainless products, measured and cut to your flue’s exact dimensions on site. We document the full insertion with camera footage before and after, and the installation carries our 365-Day Done Right Promise.

Flexible Liner Installation

Flexible liners are corrugated stainless steel tubes that navigate offsets and bends in chimney flues where rigid pipe won’t fit. We see this need frequently in Olympia’s mid-century homes in the Governor Stevens and Indian Creek areas, where chimneys were often built with sharp turns to accommodate floor plans. The flexibility allows a complete flue lining without dismantling interior walls. We source our flexible liners through Haven’s buying network, primarily DuraFlex and Gelco products, and every installation is pressure-tested and camera-verified before we call it complete.

Liner Replacement

Liner replacement becomes necessary when the existing flue liner has deteriorated beyond repair, cracked, or separated at the joints, creating gaps where heat and combustion gases can reach combustible framing. In Olympia, we replace liners most often in homes where previous owners burned wet wood for years, accelerating thermal shock damage to clay tile. We remove the failed liner, inspect the surrounding masonry with a camera, and install a new system sized precisely for your appliance’s BTU output and venting requirements. The written scope specifies every component, every material source, and every warranty term before we start.

Partial Chimney Rebuild

A partial rebuild addresses damage confined to the upper portion of the chimney, typically from the roofline up, including the crown, top courses of brick, and often the flue liner itself. Olympia’s wind-driven rain, especially in the exposed hills above Cooper Point and along Budd Inlet, accelerates crown failure and spalling in these areas. We rebuild using matching brick when possible, pour a new concrete crown with proper overhang and drip edge, and install a compatible liner system. The Haven Standard requires that we photograph every course as it’s laid and provide those images in your job record.

Full Chimney Rebuild

A full chimney rebuild is required when structural damage extends below the roofline, compromising the chimney’s stability or creating multiple points where combustion gases can leak into wall cavities. We’ve completed full rebuilds in Olympia’s older neighborhoods, particularly in homes near the historic district where century-old chimneys have settled, tilted, or suffered catastrophic liner collapse. The process involves careful dismantling, foundation inspection, reconstruction to current code, and a new liner system. These projects take two to three days, and we provide daily photo updates and a final documented record under Clause 4.

Liner Repair and Resurfacing

Liner repair, including HeatShield cerfractory resurfacing, is an option when the existing clay tile liner is structurally sound but has minor cracks, gaps, or surface deterioration. HeatShield is a ceramic refractory compound that fills voids and restores a smooth, sealed flue surface without full liner replacement. We evaluate candidacy with a camera scan; if the tile is intact and the damage is limited, resurfacing can save significant cost. In Olympia, this works well for liners with isolated thermal cracking that hasn’t progressed to full separation. We apply the material, then camera-verify the seal before the job is closed.

Brands We Service for Chimney Liner & Rebuild

We install and service chimney liner systems from DuraFlex, HeatShield, Gelco, and Copperfield, with direct procurement through Haven’s buying network to keep pricing transparent. DuraFlex flexible and rigid stainless liners make up the majority of our installations; we’ve put in hundreds of their systems across Thurston County and maintain stock for common flue sizes to reduce wait times. HeatShield’s cerfractory resurfacing system is our go-to for repairable clay tile liners, and our technicians are factory-trained in the application protocol, which requires specific surface prep and curing conditions that we verify with camera inspection at each stage.

Gelco and Copperfield components, including caps, collars, and connector hardware, round out our material inventory for jobs requiring custom transitions or repairs to existing installations. Whether your current system is one of these brands or any other make, we can evaluate it, source compatible materials, and provide a written scope and price before any work begins. Our free second opinion applies to any competitor’s written estimate for liner or rebuild work in the Olympia area.

Before

After

Signs You Need Chimney Liner & Rebuild Right Now

• White efflorescence or spalling brick on the chimney exterior. These deposits indicate water is migrating through the masonry, dissolving salts, and pushing them to the surface. In Olympia’s climate, this accelerates rapidly once it starts, and it often means the liner has failed and moisture is reaching the brick from inside the flue. A camera inspection will show whether the damage is localized or systemic.
• Flakes or pieces of clay tile in the firebox or cleanout. This is direct evidence that the flue liner is deteriorating. Those pieces came from somewhere inside your chimney, and every missing section creates a gap where heat can reach combustible materials. We document the extent with a Level 2 camera scan and provide a written replacement scope.
• Smoke or odors entering living spaces during operation. A properly lined chimney should contain all combustion byproducts. If you’re smelling smoke or getting backdraft, the liner may be cracked, improperly sized, or missing entirely. This is a carbon monoxide exposure risk, and we treat these calls as priority inspections.
• Visible cracks in the chimney crown or missing mortar between bricks. Crown failure allows water directly into the chimney structure, and once freeze-thaw cycling begins, the damage compounds quickly. In Olympia, we see this most on chimneys without proper overhang or drip edge. A compromised crown often correlates with liner damage below, and we inspect both as a system.
• Your home inspection flagged the chimney, or your insurance requires documentation. Many Olympia homeowners first learn of liner issues during a sale or renewal. We provide NFPA 211 Level 2 inspections with documented photo records that satisfy insurer and buyer requirements, and we can quote any needed work in writing before closing or renewal deadlines.

Our Chimney Liner & Rebuild Process - Step by Step

1. 1
   Schedule and confirm. Call (360) 464-2015 and you’ll reach a live person, 24 hours a day. We book a two-hour arrival window, assign a named technician, and text you when they’re en route. Background-checked, uniformed crews arrive in marked vehicles.
2. 2
   NFPA 211 Level 2 inspection with camera documentation. Before quoting any liner or rebuild work, we run a camera the full length of the flue, inspect accessible portions of the chimney exterior and interior, and document conditions with photos and video. This is Haven Standard Clause 4, and we’ve done it on every job since 2009. You see what we see.
3. 3
   Written scope, written price, written warranty. Within 24 hours of inspection, you receive a detailed proposal: exactly what we found, exactly what we recommend, exactly what it costs, and exactly what’s warranted. No verbal estimates, no “we’ll figure it out when we start.” Clause 1 of the Haven Standard requires this in writing before any work begins.
4. 4
   Scheduled execution with daily documentation. Once approved, we order materials through Haven’s buying network and schedule the work. For rebuilds, we photograph each stage: demolition, foundation condition, reconstruction progress, and final assembly. You’re never guessing what’s behind the wall or under the roof.
5. 5
   Final camera verification and documented record delivery. After completion, we camera-verify the new liner or rebuilt chimney, test all connections and clearances, and deliver your final photo record, written warranty, and maintenance recommendations. The 365-Day Done Right Promise covers everything we’ve done; if it’s not right, we make it right.

How Much Does Chimney Liner & Rebuild Cost in Olympia?

Chimney Liner & Rebuild Near Olympia - Our Service Area

We perform chimney liner installation, liner repair, and full and partial chimney rebuilds throughout Thurston County and into neighboring Pierce and Mason counties. Our standard service area includes Chimney Liner & Rebuild in Lacey, Chimney Liner & Rebuild in Tanglewilde, DuPont, Yelm, Shelton, Fort Lewis, Steilacoom, Lakewood, University Place, Artondale, and Fircrest. Most liner installations in the core Olympia area are scheduled within three to five business days; rebuilds requiring masonry cure times are booked with weather contingency built in. Call (360) 464-2015 to confirm availability for your address.

Frequently Asked Questions - Chimney Liner & Rebuild in Olympia

Schedule Your Chimney Liner & Rebuild Service in Olympia Today

Call (360) 464-2015 to book your NFPA 211 Level 2 inspection. You’ll speak to a live person, 24 hours a day. We’ll run the camera, show you what we find, and deliver a written price, written scope, and written warranty before any work begins. Estimates are free, and we provide a free second opinion on any competitor’s written quote. Corrine Halstead and the team at Level Two Chimney Olympia have documented every job with photos since 2009, and that practice isn’t changing.

Written by Corrine Halstead, Owner at Level Two Chimney Olympia, serving Olympia, Lacey, Tanglewilde, and surrounding communities since 2009.